Open Access Open Access  Restricted Access Subscription or Fee Access

Design & Development of Underwater Load Cell for Deep Sea Applications

Anirban Mazumdar, P. Sakthivel, P. Muthuvel, R. Ramesh, C.R. Deepak, M.A. Atmanand

Abstract


Load cells are the devices which can be used for different types of weighing applications. This paper presents the design of a pressure compensated strain gauge based load cell which can be operated for various deep sea applications. This load cell is a transducer that is used to convert a force or load into electrical signal. This conversion is indirect and happens in two stages. Through a mechanical arrangement, the force is sensed which deforms the strain gauge and the deformation (strain) is measured as an electrical signal, because the strain changes the effective electrical resistance of the wire. This load cell is designed with full Wheatstone bridge configuration for detecting both tension and compression load and also for ensuring better accuracy. The electrical signal output is typically of the order of a few mill volts and needs conditioning with necessary signal processing circuitry before it can be used further. Finally the device needs to be enclosed inside a pressure compensated enclosure which can withstand 600 bar outside pressure. The device is mainly designed considering the Indian Ocean parameters and it will work at a depth of 6000 meters under water.

Keywords


Load Cell, Strain Gauge, Strain, Transducer, Wheatstone Bridge, Signal Conditioning, Enclosure

Full Text:

PDF

References


Anirban Mazumdar, P.Sakthivel, P. Muthuvel & R.Ramesh, “Design of underwater load cell for deep sea applications”, Conference Publications, International Conference On Computing And Control Engineering, ICCCE2012, April 2012.

Baoxiang He, Guirong Lu, Kaibin Chu, Guoqiang Ma, “Development of high accuracy and low capacity strain gauge based load cell for electronic scale”, Electronic Measurements & Instruments, 2009, ICEMI'09, 9th International Conference.

Carlose Couto & Jose Higino, “Digital filtering in smart Load Cell”, Department of Electronics Industrial, University Of Minho, Portugal.

C.Winkelmann, O.Woitschach, E.-M. Meyer and W. Lang, “Development of a strain sensor for rolling contact loads”, University of Bremen, Institute for Micro Sensors, Actuators & Systems, Bremen, Germany.

M. Jaraipanah, B.M. Al-Hashimi & N.M. White,“Load Cell response correction using analog adaptive technique”, ESD Group, Dept of Electronics & Computer Science, University of Southampton, UK.

N. Madhu Mohan, “Novel Signal Conditioning Circuit for Push Pull Type Transducer”, Master of Science in Electrical Engineering, Indian Institute of Technology, Madras.

Robert F. Coughlin & Frederick F. Driscoll, “Operational amplifiers and Linear Integrated Circuits, Sixth edition”, Wentworth Institute of Technology.

Mark Stitt & David Jones, “Use of low-impedance bridges on 4-20 mA current loops”, BURR BROWN Corporation.

Yanmin Li & Qingfeng Wang, “Research On Pressure Compensation for Underwater Hydraulic Systems With Underwater Ambient Pressure-Compensated Valve”, The State Key Laboratory of Fluid Power Transmission and Control, Zhejiang University, Hangzhou, People's Republic of China

Nautilus Minerals Inc. “Deep Sea Prospecting for Minerals, Oil, Gas, The Motherlode”.

Revere Transducers Europe, The Netherlands “Load Cell Technology In Practice, Application note”.


Refbacks

  • There are currently no refbacks.


Creative Commons License
This work is licensed under a Creative Commons Attribution 3.0 License.